New 9 pin header installed and recapped the power supply.
Replaced both connectors, the label maker also got a workout.
Wednesday, 6 August 2014
Simpsons Pinball - Bad connectors
A common problem on Pinball machines is burnt molex connectors due to the long hours they were run for and heat build up.
What a mess, notice the wires connected to the test points. These go to the new coin mech as this was originally an american machine. I am sure there must be a closer gnd / 12v source to tap into rather than the backbox and directly to the power supply.
Hmm toasty, this connector plugs into the playfield power board (PPB).
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment